The following are the available to use on the VM console (IS and LSS):
date – displays current system date and time. To set current system date/time, enter in the following format:
AVDS > date MMDDhhmmYYYY
halt – safely shuts down AVDS server
reboot – safely reboots AVDS server
enable – enables console restriction via a password
disable – disables console restriction
service ssh start – activates Secure Shell for remote diagnostics/troubleshooting
service ssh stop – deactivates Secure Shell for remote diagnostics/troubleshooting
rlb admin – resets Web GUI password to factory default
rlb server – resets server to factory default
show – displays configuration settings
save - saves configuration. Must be used after a configuration change, or settings will not be saved after reboot.
quit – returns to main AVDS prompt
help – displays list of available commands
network – network configuration utility. See sub-commands below.
interface – sets active network interfaces, ex. “network interface eth0”
network interface eth0
ip – display or set IP address
netmask – display or set subnet mask
broadcast – display or set broadcast addresses
dhcp – display or set use of DHCP
save – saves configuration
exit – returns to parent menu
vlans – sets active VLANs on network interface, e.x. “network vlans eth0”
route – enter route configuration mode
gateway – display or set default gateway address, e.x. “network gateway 192.168.1.1”
ns - configure DNS, e.x. ns 8.8.8.8
ping – ping destination address
arp – displays ARP table
ifconfig – displays network interface table
netstat – displays the network routing table
traceroute – traceroute destination address
telnet – telnet to destination
show – shows network configuration
devices – shows devices
hosts – view and modify the etc/hosts file
save – saves configuration. Must be used after a configuration change, or settings will not be saved after reboot.